adjtime_config - information about hardware clock setting and drift factor
The file /etc/adjtime contains descriptive information about the hardware mode clock setting and clock drift factor. The file is read and write by hwclock(8); and read by programs like rtcwake to get RTC time mode.
The file is usually located in /etc, but tools like hwclock(8) or rtcwake(8) can use alternative location by command line options if write access to /etc is unwanted. The default clock mode is "UTC" if the file is missing.
The Hardware Clock is usually not very accurate. However, much of its inaccuracy is completely predictable - it gains or loses the same amount of time every day. This is called systematic drift. The util hwclock(8) keeps the file /etc/adjtime, that keeps some historical information. For more details see "The Adjust Function" and "The Adjtime File" sections from hwclock(8) man page.
The adjtime file is formatted in ASCII.
Three numbers, separated by blanks:
the systematic drift rate in seconds per day (floating point decimal)
last adjust time
the resulting number of seconds since 1969 UTC of most recent adjustment or calibration (decimal integer)
zero (for compatibility with clock(8)) as a floating point decimal
last calibration time
The resulting number of seconds since 1969 UTC of most recent calibration. Zero if there has been no calibration yet or it is known that any previous calibration is moot (for example, because the Hardware Clock has been found, since that calibration, not to contain a valid time). This is a decimal integer.
Supported values are UTC or LOCAL. Tells whether the Hardware Clock is set to Coordinated Universal Time or local time. You can always override this value with options on the hwclock(8) command line.
For bug reports, use the issue tracker at <https://github.com/util-linux/util-linux/issues>.
adjtime_config is part of the util-linux package which can be downloaded from Linux Kernel Archive <https://www.kernel.org/pub/linux/utils/util-linux/>.